C3-SX950-WR Slot type ultra-compact photoelectric sensor
Description
C3-SX95 series slot type photoelectric sensor is non-contact method, make use of the target object shelter the light beam, through synchronizing circuit to convert to a switching value output, able to detect non-transparent object with min. 0.8x2mm, thickness less than slot width 5mm.
Slot type photoelectric sensor is mainly using at auto monitoring auto control, auto countering devices etc.
Features
1. High water proof level, reach IP67 class, able to apply at bad enviroment
2. Multi installation method to meet different application space.
3. High response frequency 1kHz
4. Output configure have light-ON and dark-ON method
5. Wide voltage range 5-24VDC
6. High visible red LED indicating light
Model Meanings
Specification
| Item |
Specifications |
| Power supply range |
5-24V DC |
| Light source |
Infrared LED, wave length 940nm |
| Sensing distance |
5 mm (slot width) |
| Current consumption |
< 25mA |
| Output |
NPN type, PNP type |
| Max. load current |
100mA |
| Min. sensing object |
Opaque: 0.8mm*2mm |
| Residual voltage |
< 1.0V with 50mA load current |
| Response frequency |
1 kHz min. (max. 3 kHz) |
| Switch mode |
Light-ON / Dark-ON |
| Differential travel |
0.025mm max. |
| Protection Circuit |
Reverse polarity protection |
| Ambient illumination |
1000 lx max. with fluorescent light on the surface of the receiver |
| Ambient temperature range |
Operating: -25 to +55ºC |
| Storage: -30 to +80ºC |
| Connection method |
Pre-wired |
| Withstand voltage |
1000VAC between current-carrying parts and case |
| Vibration resistance |
10Hz to 2000Hz |
| 1.5mm double amplitude for 2 hours each in X,Y and Z directions |
| Shock resistance |
15000m/s2 (about 1500G) for 3 times each in X,Y and Z directions |
| Insulation resistance |
> 20MΩ between all current-carrying parts and case with DC250V megmeter |
| EMC |
Static test: air discharge 8kV, electrical fast transient pulse group |
| Degree of protection |
IP67 |
| Material |
ABS |
Circuit diagram
Applications
Maintenance and Inspection
In order to ensure long-term stable operation of the photoelectric switch, please carry out the following periodic inspections;
1. Check that the installation position of the detection object and the photoelectric switch is offset, loose, and deformed.
2. Check the wiring, whether the connection part is loose or not, and the contact is broken.
3. Check for any deposits such as sticky metal dust.
4. Check the operating temperature and whether there are any abnormalities in the surrounding environment.
Our Factory
Audited Supplier 
){kind=link}
){kind=link}